Step 3 | Gluing the Botanicals | How-To: Make a Woodland Candle Holder | Resources for Log Homes |
![]() |
How To: Make a Woodland Candle Holder Step 3: Gluing the Botanicals |
|
| Step 3: Gluing on Your Botanicals | |
Using the foam brush, apply a thin layer of the decoupaging glue to the glass container. Place your botanical on the glass, then carefully brush another thin layer of glue over the leaf, fern, flower, etc. On word on your glue: It’s important that it’s not too thick (it won’t create a nice glowing effect when the candle’s lit if it’s too thick) or too thin (it will be hard to work with or won’t hold your design if it’s too thin). We used Mod Podge since it was the right consistency, but other brands would work fine, too. Just make sure it looks like milk: thick enough that you can’t see through it, but thin enough that it pours easily. |
|
Continue applying your bontanicals until you’ve achieved your desired design. We worked with one variety at a time, gluing on all of the skeleton leaves first and then going back and placing some fern springs around them.Do be sure that you’re leaving some room, though. If you have too many leaves and flowers on the glass, not enough light will filter through when you have a candle lit. |
|
Brush one last thin layer of glue over the entire design once you’ve finished placing your botanicals. |
|
Let that glue dry. This should take about 30 minutes, and you’ll know it’s ready because the glue will dry clear. |
|
| What You'll Need | Determining Design | Gluing the Botanicals | Finishing Touches |
![]() |
![]() |
![]() |
![]() |
Back: How to Make a Candle Holder
Leah's Ideas Archives: Homemade Decor
More: Cabin Decor Ideas
|
Give Country's Best Log Homes as a Gift Subscription
|
Give Log Home Living as a Gift Subscription
|
Country's Best
|
Log Home Living
Subscribe You may call us if you prefer not to order online: 800-234-8496 If you are not in the continental U.S. please call 386-447-2398 (International).
You can also write to: |




Brush one last thin layer of glue over the entire design once you’ve finished placing your botanicals.
Let that glue dry. This should take about 30 minutes, and you’ll know it’s ready because the glue will dry clear.


